Milestone ML 202 HDMI, Руководство по эксплуатации

Страница: 6 / 8


IR Remote : - All the new switcher has IR sensor on the front panel.
IR-8 Remote is provided with the equipment to select the channels.
On the rear side one EP Connector (IR.EXT,) is provided for
connecting IR sensor cable which can be extended upto 30Mts.

SCANNING MODE
For scanning mode, keep slide-switch at the rear panel in scan
position before powering ON the unit. Set the DIP SWITCH for the
Channels to be Scanned (see the note below).
PWR ON the unit & check SCAN LED. Scanning time for each
channel is 20 seconds (default).
To stop the scanning press any channel key from the remote
keypad. To start scanning press scan Key (Mute) from the remote
keypad. Front Panel has LED to indicate Scan mode status.
Note : The I/P channels will be scanned depending on the DIP Switch
setting (not for 201HDMI & 202HDMI) eg. for scanning 1, 3 & 5,
Keep the DIP Switch 1,3 & 5 ON. Rest all OFF.
The Scan time can also be set using DIP Switch (not for 201HDMI &
202HDMI).
1) PWR OFF the unit.
2) Set the DIP Switch as per Table 1.
3) Press key No.1 from the front panel.
4) Keeping the key no.1 pressed PWR ON the unit
5) If the timer is set properly Scan LED will start blinking.
6) PWR OFF the unit.
7) Set the DIP Switch for the channels to be scanned.
8) PWR ON the unit (with scan mode ON).
9) The I/Ps will start scanning depending on the time set.