2
4. Run harness assembly to mounted position of
junction box, securing harness to framing using
insulated staples (not included).
5. Feed harness assembly through a restrain on rear of
junction box, feeding through until harness sheath
is pinched by retainer and providing sufficent length
to make connection to rear of switch and battery
holder.
6. Secure junction box to the mounting surface using
appropriate fasteners (not included).
7. Align
Molex
connection on switch cable of harness
assembly and connect to switch.
8. Mount switch plate to
junction box with 2 screws
provided.
Switch position left or right
to suit homeowner wishes.
Installation
Locate the receiver in the appliance’s case. Refer to the
appliance’s installation manual if necessary.
1. Pull out the receiver from its location to connect the
battery holder and wall switch.
2. Feed the ‘white connector end’ of the harness
assembly through side holes in fireplace liner body
to receiver. Ensure sufficient harness length to allow
for removal of receiver. Coil up any extra harness at
fireplace end.
3. Connect switch to auxillary 5 pin junction and
power connection to jack.
NOTE
If retrofitting this kit to an existing installed
fireplace, disconnect the battery box from the
receiver, remove the batteries and discard the
battery box. Refer to the fireplace installation
manual for the location.
Caution
Do not run the switch wire over the top of the
firebox. Route the wire so it does not contact
the firebox.
