Install Guide
Model: MIL-03F
2
I n t ro d u c t i o n
The MIL-03F is an Ethernet, single-mode fiber transceiver that comes equipped
with diagnostic LEDs, an AUI male connector, and either an SC- or ST-type fiber
connector.
I n s t a l l a t i o n
1. Connect the fiber cables: Attach the fiber cables from the fiber network cabling
to the ST-type connectors on the MIL-03F.
2. Attach the 15-pin AUI connector from the MIL-03F to the DB-15 connector on
the device you wish to connect to.
3. Tighten the latch screws to secure the unit.
4. Restart the computer. The
PWR
LED illuminates.
Note:
If the
PWR
LED did not illuminate, reinstall the MIL-03F. If it still does not illuminate, contact
our technical support department.
C o n fi g u r a t i o n
The MIL-03F comes with configurable options, which include a 2-position DIP
switch and a 3-pin jumper. The DIP switch is located on left-side of MIL-03F
(while facing the device), and the jumper is located inside the device. To open the
MIL-03F to access the 3-pin jumper:
1. For device's with ST-type connectors, unscrew the two hex nuts that secure the
ST-type connectors.
2. Slide the top-half of the enclosure off, over the fiber connector.
The jumper is located on right-hand side of the device (Figure 1).
D I P S w i t ch
The Link Sentry feature on the MIL-03F is configured through the 2-position DIP
switch located on the side of the transceiver. Use a mechanical pencil to adjust the
DIP switches.
LinkSentry transmits link pulses only if the receive side of the link is seen. This
allows fault-tolerant transceivers and hubs to detect faulty cables or bad
equipment. Settings for the DIP switch includes:
Table 1: DIP Switch Settings
Up (off)
Down (on)
Switch 1
LinkSentry disabled (Default)
LinkSentry enabled
Switch 2
SQE disabled (Default)
SQE enabled
