EasyPIC5 KEY FEATURES
1.
External power supply connector 8 - 16V AC/DC;
2.
Power supply selector. It is possible to use external or
USB power supply. When using USB port, there is no
need for external power supply;
3.
Power ON/OFF switch;
4.
On-board USB programmer with mikroICD support. Its
key feature is an ability to upgrade. By downloading a
new software, it will be possible to program new MCUs
in coming years;
5.
RS-232 communication module with selectable TX and
RX for all microcontrollers;
6.
USB port for MCU with USB support;
7.
PC keyboard connector;
8.
DS1820 temperature sensor connector;
9.
A/D input selector used for testing the operation of A/D
converter. It is connected to potentiometers P1 and P2;
10.
7- segment displays in multiplex mode;
11.
16-pin connector allows an easy connection of LCD;
12.
LCD contrast potentiometer;
13.
DIP switch SW6 turns on/off LEDs on ports A, B, C, D
and E and enables digits on 7-segment LED display.
DIP switch SW9 turns on/off touch panel controller, PS/2
and LCD and GLCD backlights;
14.
EasyPIC5 supports microcontrollers in DIP8, DIP14,
DIP18, DIP20, DIP28 and DIP40 packages;
15.
Jumper to determine port performance in idle state (pull-
up/pull-down). Select pull-up to enable port pins to detect
logic zero (0) and vice versa;
16.
PORTA connected to a resistor network using DIP switch
SW1. If a switch is OFF, the appropriate pin does not have
a resistor attached. It enables PORTA pins to be used in
analog mode as well as digital I/O pins. The same applies
to other ports: PORTB, PORC, PORTD and PORTE;
17.
36 LEDs connected to the microcontroller I/O ports;
18.
20-pin connector allows an easy connection of graphic LCD;
19.
Graphic LCD contrast potentiometer;
20.
Reset circuit;
22.
36 push buttons allow control of every pin on the micro-
controller;
21.
Jumper to select high/low state of an input pin when the
appropriate push button is pressed;
23.
Touch panel connector; and
24.
Touch panel controller.
4
4