Mikasa 450125, Руководство по эксплуатации

Страница: 25 / 30

Changing the Clutch
Remove the V-belt. (See the belt removing
steps described in the previous page.)
Remove the bolt at the engine output shaft end
by applying an impact (hitting with a hammer)
to the spanner. (in a counterclockwise direc-
tion).
Remove the clutch with a pulley remover.
For installation, perform the previous steps in
reverse. When tightening the bolt, apply a
shock to the spanner to tighten securely.
If vibration becomes weaker during opera-
tion or when there is no vibration even
though the engine is running normally,
immediately check the V-belt and clutch
with disregard to the rule of every 200 hours
check.
At every 100 hours of operation, set the
machine on a level surface and remove the oil
gauge of the vibrator. Check the oil level to see
if it is within the allowable range. (Fig.17)
Change the vibrator oil at every 300 hours
operation. Drain the oil from the drain plug. For
draining, put a beam under the compacting
board at the other side of the drain plug to tilt
the machine.
Use engine oil SAE 10W-30 as lubrication
oil. The quantity used is 200cc for MVH-R60.
When checking the vibrator oil, clean the oil
port beforehand to prevent dust and other
foreign materials from falling into the oil.
Whenever there is an oil leakage from the
vibrator, check the oil level.
Check the Hydraulic Oil
Check the hydraulic oil at every 100 hours’
operation. By making the handle bar vertical
(done at the time of storage), remove the
breather plug at the top of the hydraulic hand
pump to see if the hydraulic oil is at the speci-
fied level (OIL LEVEL). (Fig. 18)
4.
-
-
-
-
※
1.
fig.17
(IIHFWLYH
)RU09+5
㻹㼑㼍㼟㼡㼞㼑㻌㼛㼕㼘㻌㼢㼛㼘㼡㼙㼑㻌
㻺㼛㼠㻌㼚㼑㼏㼑㼟㼟㼍㼞㼥㻌㼠㼛㻌㼟㼏㼞㼑㼣㻌
fig.18
㻯㼍㼜
㻮㼞㼑㼍㼠㼔㼑㼞㻌㻼㼘㼡㼓
㻴㼍㼚㼐㻌㻼㼡㼙㼜
㻻㻵㻸㻌㻸㻱㼂㻱㻸
CAUTION
䟿
CAUTION
䟿
12-5. Checking/Changing the Vibrator Oil
(Fig.17)
12-6. Checking/Changing the Hydraulic Oil
21