Programming manual V1.1
www.parapulser.com
7
Display of pulse consumption
On
/
Off
switching:
1.)
Activate
Programming-mode
, see “
8
a)
”
on page
2
.
2.)
Activate Input-mode:
CODE
-key press
2
sec., until
3
“
Piep!
”-tones are audible. The input-mode is now acti-
vated: the
red
LED blinks
1
x per second and in addition a Piep-tone is audible!
3.) 2
-digit number “
15
” input:
Jump to chapter “
8.13
" on page
11
and follow the instructions for number entering. Af-
terwards it continues here with point
4.)
4.)
Acoustic confirmation of
On
/
Off
switching:
Directly after the input of the second digit (number “
5
”), an acoustic signal is audible:
– At
On
switching the consumption display, a “
Dulip!
”-signal is audible,
– At
Off
switching the consumption display, a long “
Beeeep!
”-tone is audible,
Afterwards, the input-mode is terminated automatically and all three LED (
=
=
=
) light
up again.
8.7
Upgrade-Frequency increase / readout [
16
]
The upgrade frequency can be increased up to
20
Hz against payment, see “
6.2
”, on page
8
.
Upgrade-frequency increase:
1.)
Order
6
-digit upgrade CODE-number at your
Parapulser
salesman.
2.)
Enter the CODE-number as described at “
8.13
”, page
11
. After successful CODE-input
the increased upgrade-frequency can be checked by readout right away:
Readout upgrade-frequency (
1
or
2
-digit):
1.)
Activate
Programming-mode
, see “
8
a)
”
on page
2
.
2.)
Activate Input-mode:
CODE
-key press
2
sec., until
3
“
Piep!
”-tones are audible. The input-mode is now acti-
vated: the
red
LED blinks
1
x per second and in addition a Piep-tone is audible!
3.) 2
-digit number “
16
” input:
Jump to chapter “
8.13
” on page
11
and follow the instructions for number entering. Af-
terwards it continues here with point
4.)
.
4.)
Write down the displayed numbers:
The
Parapulser
now shows with help of the LEDs (
=
=
=
) the
first
digit of the up-
grade-frequency. Write down this number.
5.)
Remaining digits of upgrade-frequency readout:
rest
-key
short
press, and after each actuation, write down the via LED (
=
=
=
) dis-
played number (
0
–
9
) right beside the already noted number(s).
Repeat this procedure until a long “
Beeep!
”-tone signalizes, that all digits have been
readout. The input-mode is automatically terminated and all three LEDs (
=
=
=
) light
up again.
