27
Installing the Receiver
Use the transmitter to check the range of the receiver before permanently mounting it.
Consider the following when mounting the receiver:
• Standard receiver cable length is 10 feet (receivers with a longer cable are available as special
order items;
call the GTO Sales Department
). NEVER splice receiver cable!
•
Run the cable through PVC conduit to protect it from damage.
• DO NOT run cable in conduit containing ac wiring.
• DO NOT mount receiver on a metal fence or post; doing so will decrease signal range.
• The receiver range can vary from 50 to 100 feet depending upon weather, topography, and
external interference.
•
DO NOT
mount upside down.
•
MOUNT
so that you have line of sight between remote and antenna.
•
MOUNT
3 feet away from AC voltage.
•
MOUNT
as high as possible for optimum range.
FCC Regulation
This device complies with FCC rules Part 15. Operation is subject to the following
conditions:
1. This device may not cause harmful interference.
2. This device must accept an interference that may cause undesired operation.
Transmitter distance may vary due to circumstances beyond our control.
NOTE:
The manufacturer is not responsible for any radio or TV interference caused by
unauthorized modifications to this equipment. Such modifications could void the
user’s authority to operate the equipment.
Obstruction Sensitivity Potentiometer
ALWAYS KEEP
SAFETY
AT THE TOP OF YOUR LIST WHEN ADJUSTING OR
SERVICING YOUR AUTOMATIC GATE OPENER!
1 2 3
4
ON
OFF
SOFT START OFF
WARNING OFF
OPEN PULL
SLV OPEN DLY.
MODE1 OFF
MODE2 OFF
ON
ON
PUS
SIM
ON
ON
120 MIN
AUTO CLOSE TIME
STALL FO
1
2 3
4
O
N
OFF
SOFT START OFF
WARNING OFF
OPEN PULL
SLV OPEN DLY.
MODE1 OFF
MODE2 OFF
ON
ON
PUS
SIM
ON
ON
120 MIN
O CLOSE TIME
STALL FO
O
S
M
TO
O
1
2
ON
ON
ON
0 MIN
MAX
E
STALL FORCE
MIN
MAX
STALL FORCE
IMPORTANT:
For safety reasons the
obstruction setting or
Stall Force
on the
GTO® gate opener control board comes from
the factory set at
MIN
(minimum). In many
gate installations this setting will need to be
adjusted to overcome the weight and size of
the gates.
The
Stall Force
potentiometer on the control
board operates like a volume control on a radio.
It controls the obstruction sensitivity (or the amount
of force the opener will apply to an obstruction)
before it automatically stops and reverses direction for
approximately two (2) seconds.
Use a small flat blade screwdriver to turn the arrow in the center of
the potentiometer. Adjust the sensitivity from the MINIMUM position
where the gate operates without obstructing from its own weight or the
wind conditions in your area.
NOTE: You may need to increase the stall force in cold weather due to
increased resistance from gate hinges.
