Mighty Mule FM137, Инструкция по эксплуатации

Страница: 3 / 16

3
Thank you for purchasing the FM137 Digital Keypad . Be sure to read the directions carefully and completely . Before permanently
mounting the keypad, please program the keypad and test its range .
IMPORTANT: Your keypad may need to be hard wired due to the fact that it must accept interference according to FCC regulations
listed below . For example, applications that are relativity close to cell towers or airports may receive intermittent interference and
require hard-wiring .
The FM137 Digital Keypad is a multipurpose keypad that can work with other applications in addition to Nortek Security & Control
(NSC) gate openers and locks . As a wireless keypad it can be used with any gate or garage door opener and must be used in
conjunction with the NSC garage door receiver kit (part # RB709U-NB) .
SAFETY NOTE:
Never install the keypad where a person can reach through the gate to activate it, or where a person can touch the
gate while activating the keypad . The recommended minimum distance between the gate and keypad is 10 ft .
Keypad Features
Keypad
• The keypad illuminates and beeps at the press of any key .
• When a valid code is entered, the STATUS light will blink rapidly .
• The keypad remains active for 40 seconds after entering a valid code: pressing any key on the keypad while the gate is in
motion will stop the gate; pressing any key while the gate is stopped will cause the gate to reverse direction . After 40 seconds,
the keypad will beep 3 three times and go into “idle” mode .
• If more than 20 key presses are entered without matching an Entry Code, the STATUS light will flahs rapidly, and error tone will
sound for 1 second, and the keypad will go into “lock-down” mode for 40 seconds .
• If more than 10 seconds elapse between key presses, the keypad will beep 3 three times and go into “idle” mode .
Master and Entry Codes
• Up to 25 Entry Codes may be programmed into the keypad .
• Temporary Entry Codes can be programmed to expire within one to seven (1–7) days .
• Entry Codes remain stored in memory even when the keypad batteries go dead .
• All Entry Codes are deleted by pressing the RESET button on the keypad; Master Code defaults to “1234 .”
Wireless Gate Entry Intercom