26
Error codes for Power control package 10001702.cry
Error code
Cause and solution
The file 10001702.cry has an error.
1. Insert the SD card in the machine
again.
2. Exchange the SD card.
SD card is not formatted.
The SD card must be formatted in a
PC as FAT. Or use another SD card.
The software does not match this
control unit.
Use a SD card with software that
matches your control unit.
DSP-PCB is defective
Contact
MIGATRONIC
Service
Data transmission error
Turn on and off the machine.
Exchange the SD card if the error is
displayed again. Contact your dealer
if necessary.
The file 10001702.cry has an error.
1. Insert the SD card in the machine
again.
2. Exchange the SD card.
DSP-PCB is defective
Contact
MIGATRONIC
Service
The SD card contains too many files
with 10001702.cry-data
MAINTENANCE
The machine requires periodical maintenance and
cleaning in order to avoid malfunction and cancellation
of the guarantee.
WARNING !
Only trained and qualified staff members can carry
out maintenance and cleaning. The machine must
be disconnected from the mains supply (pull out
the mains plug!). Thereafter, wait around
5 minutes before maintenance and repairing, as all
capacitors need to be discharged due to risk of
shock.
Wire cabinet
- Regularly, clean the wire cabinet with compressed
air and check if the grooves and teeth on the wire
drive rolls are worn out.
Cooling unit
-
Liquid level and frost protection must be checked
and cooling liquid refilled as required.
-
Drain the cooling liquid out of the cooling module
and welding hoses. Remove dirt and flush with
pure water in the tank and cooling hoses. Fill up
with new cooling liquid. The machine is delivered
with a cooling liquid of type propan-2-ol in the ratio
23% propan-2-ol and 77% demineralized water,
which provides an anti-freeze solution up to –9°C.
(See article number in the spare parts list).
Power source
-
Clean the fan blades and the components in the
cooling pipe with clean, dry, compressed air as
required.
-
A trained and qualified staff member must carry out
inspection and cleaning at least once a year.
WARRANTY REGULATIONS
Migatronic continuously carries out quality control throughout the manufacturing process as well as
check of the complete units through comprehensive testing.
Migatronic provides warranty in accordance with the following provisions, by correcting errors and
defects on units, that demonstrably and within the warranty period may have been caused by faulty
material or workmanship.
The warranty period is 24 months for new welding machines, 12 months for new accessories and 6
months for spare parts. The warranty period is calculated from the date of invoice to the end user from
Migatronic or Migatronic’s dealer/distributor. In the case of sales through Migatronic’s dealer/distributor,
the warranty period expires in any event within 36 months for new welding machines and 30 months for
spare parts from the date of invoice from Migatronic to the dealer/distributor. This extension in no way
extends the warranty period. The original invoice is proof of the warranty period.
Welding torches are considered as wearing parts, and only errors and defects found within 6 weeks upon
delivery and due to faulty material or workmanship, will be considered under warranty.
Warranty repairs neither extend nor renew the warranty period.
Any transport of goods or persons in connection with a warranty claim is not covered under Migatronic’s
warranty obligation and will therefore be at the buyer’s expense and risk.
Please also refer to
www.migatronic.com/warranty
