unpacking;
Check the equipment. If it is damaged, please keep wrappers and
receipts which must be signed by the carrier representative (Driver),
and contact the carriers to pursue a claim within 15 days after
receiving;
Check all accessories complete. Refer to P15 table 5;
Be sure to install supporting legs before using, and do not tear up
any label or logo before normal using;
Please read these instructions carefully before installation and
operation. Please contact your local agent if you have any questions;
The char broiler shall be installed on a level, solid, non-skid and
incombustible surface, and placed in a well-lighted work area with
waterproof, and stay away from children and customers;
The installation position is a well-ventilated place in accordance
with the local regulations;
The char broiler must be installed under the matched cooking fume
exhauster according to the local regulations;
Important: Installation and ventilation laws, and codes are
very different, you should state and comply with all codes of
the National Fire Protection Association Inc when it comes to
requirements for installation of equipment;
Screw 4 adjustable stainless steel legs in the tapping hole at four
corners of the char broiler bottom, ensure sufficient space for
ventilation;
Adjustable stainless steel legs to make the equipment level, and
get the same level with other series of the equipment; Please lift the
equipment rather than drag if you need to move it;
Supplied gas pressure regulator is factory set at 4”Natural Gas W.C,
and 10”L.P. Gas W.C;
The equipment can only be placed on the incombustible counter
top, and keep a distance at least 6 inches(152mm) to equipment’s
both sides and back, and keep a distance at least 4 inches(102mm) to
the bottom;
Do not put anything around the equipment, and on the counter top
and bottom, in order to avoid influencing combustion and air
circulation;
Leave enough distance in front of the equipment to take apart the
control panel. All major parts, in addition to the burner remove from
the front intake-tube;
It may be necessary to adjust the balance of air input by authorized
and licensed technicians;
Thread glue must be resistant to the action of liquefied petroleum
gases.
Warning! Use soap water or testing instrument to test
7
