11887140-00
Installation
*INSTALLATION*
Installation surface
A concrete floor is the most suitable
installation surface. It is far less prone
to vibration during the spin cycle than
wooden floorboards or a carpeted
surface.
Please note:
The washer-dryer must be level and
securely positioned.
To avoid vibrations during spinning,
the washer-dryer must not be
installed on soft floor coverings.
If installing on a wooden joist floor,
please note:
Use a plywood base underneath the
washer-dryer (at least
59 x 52 x 3 cm). The base must span
several joists and be bolted to the
joists and not only to the floorboards.
Tip:
If possible, install the washer-dryer
in a corner of the room, as this is
usually the most stable part of the floor.
Danger of injury due to
unsecured washer-dryer.
If the washer-dryer is installed on an
existing on-site plinth (concrete or
brick), there is a danger of the
machine falling off the plinth during
the spin cycle.
Secure the washer-dryer with a
fastening bracket (optional
accessory).
Carrying the washer-dryer to
its installation site
Danger of injury due to
unsecured lid.
The fixings at the back of the lid
could break as a result of external
forces. There is a danger of the lid
being pulled off when carrying the
machine.
Before carrying the machine, check
that the lid is secure where it
protrudes at the back of the
machine.
Carry the washer-dryer by the front
feet and by the lid where it protrudes
at the back of the machine.
Removing the transit bars
Removing the left-hand transit bar
Push the cover out and turn the left-
hand transit bar 90° using the open
spanner supplied.
