Miele WS 5073 SLUICE, Руководство по эксплуатации

Страница: 24 / 30

Problem solving guide After sales service
Laundry is either not spun at all or not
spun satisfactorily.
The “
w
No final spin” button was pushed
in.
The machine was not able to distribute the
laundry load evenly. To protect the ma-
chine, laundry was either only spun at a re-
duced speed or not at all.
Large items which tangle or roll up in the
drum (e.g. bath mats) can cause an imbal-
ance during the spin cycle.
For safety reasons, the machine does not
spin if this is the case. Attempts to build up
spin speed are repeated, however, until the
time allocated to spinning has expired.
It is therefore important to make up mixed
loads consisting of large and small items.
The drain system may be clogged.
The “
n
” indicator light flashes.
The machine has switched off because of
serious imbalance.
Switch the on-site mains switch off and
then on again or
open the drum door with the emergency
release as described in “Opening the door
in a power cut”.
The machine shakes during the spin cycle.
The most likely cause is that the four machine
feet are not resting securely on the floor.
Level the machine as described in “Notes
for the installer”.
After sales service
Should a fault occur please contact your near-
est authorized Service Dept.
When contacting the Service Department,
please quote the model type, (Typ), the ma-
chine number, (Fabr.-Nr.) und Part-no. (M.-
Nr.). These can be found on the data plate:
With the door open at the top of the door ring,
or:
at the rear of the machine towards the top.
Only use genuine spare parts. When orde-
ring spare parts the Spare Parts Dept will also
need to know the model type (Typ), machine
number (Fabr.-Nr.) und Part-no. (M.-Nr.).
M.-Nr. 05068971/03 24