What to do if . . . ?
Problem solving guide
What to do if, . . .
Cause . . .
Remedy . . .
. . . the "Soak/Pre-wash" or
"Main wash" or "Rinses 1-2"
LED is flashing?
There is a fault.
Start the programme again. If
the LED starts flashing again
call the Service Dept.
. . . The "Rinse hold" LED is
flashing?
The spin speed selector has
been set to "Rinse hold".
Select a spin speed setting.
. . . The "Final spin" LED is
flashing?
The final spin has not taken
place. The machine detected
an imbalance.
– Loosen the laundry load.
– The spin speed appropriate
for the programme should
be selected.
– Turn the programme
selector to "Spin".
. . . The "ON" LED is flash-
ing?
Programme locking is
activated. The programme
selected has been changed.
Go back to the programme
originally selected.
. . . The washing has not
been spun satisfactorily?
The spin speed selected was
too low.
Select a higher spin speed
next time.
The load was not distributed
sufficiently evenly in the drum.
Laundry was either only spun
at a reduced speed to protect
the machine
Mix large and small items in a
load to avoid imbalance.
The drain pump and fluff filter
is clogged.
Clean the drain pump and fluff
filter.
. . . The machine shakes
during the spin cycle?
The four feet are not resting
evenly on the floor.
Level the machine (see
Installation Section).
28
