Miele W 6071, Инструкции по эксплуатации и монтажу

Страница: 37 / 44

The washer must only be installed a Miele
authorized service technician.
Refer to the enclosed installation diagram.
Installation site
Horizontal access washers should be
installed on the ground floor or basement of
the construction for best results.
A concrete floor is the most suitable surface
for the washer. Concrete floors are less
prone to vibration during the spin cycle than
other floors.
The corner of a room where the stability of
the floor is at its greatest is the best place to
install the washer.
Note:
– The machine must be levelled and
securely positioned.
– To avoid vibration while spinning, the
machine should not be installed on soft
floor coverings.
– Do not install the washer on carpeting.
Carpeting will block the washer’s air vents.
– When installing the toe kick, the machine
must be secured with clamps.
– To prevent damage, do not install this
machine in a room exposed to frost or
freezing temperatures.
Shipping struts
Once the machine is in its final position the
red-marked shipping struts "
A ", " B " and " C "
must be removed.
Save the shipping struts for future use. They
must be refitted if the machine is moved.
Removing the front shipping strut
To remove the front shipping strut, unscrew
the 13 screws and the 2 lower torx screws
from the front panel.
Installation Instructions
37
“A”