Plumbing Connections
Connect the cold water intake hose
(blue mark) to the cold water valve and
the hot water intake hose (red mark) to
the hot water valve.
Turn on the valves and check for leaks.
The water pressure must be within
15-145 psi (1-10 bar). If the water pres-
sure is greater than 145 psi
(10 bar), a pressure reducer must be
installed. If the water pressure is below
15 psi (1 bar), insufficient water may be
available for a complete fill.
The water intake hoses are equipped
with screen filters. Please do not re-
move these filters.
Please note
If the machine is being connected to a
cold water supply
only
, both the hot
and cold water intake hoses should be
attached to the cold water valve
through the use of a Y adapter (avail-
able at any hardware store). Both hoses
must
be connected to a water source,
or the machine will not function prop-
erly.
Do not
connect the washer to hot
water only.
Drain connection
The 5 ft. (1.5 m) drain hose may be
connected as follows:
1
.
Directly into a sink:
hook the hose
over the edge of the sink and secure
it firmly (e.g. by tying the hose to the
water faucet).
2
.
To a stand pipe:
place the drain
hose into a 1
1
/
2
" (38 mm) stand pipe
and firmly secure it.
3
.
To a floor drain:
The machine is
equipped with an airgap/anti-siphon-
ing system so that no minimum drain
height is required.
^
The machine drains using a pump
with a maximum delivery height of
4 ft. (1.2 m).
^
Make sure there are no kinks in the
drain hose.
^
If desired, the drain hose may be ex-
tended to 15 ft. (4.5 m) maximum.
Plumbing Connections
36
