Problem solving guide
52
Other problems
Problem
Cause and remedy
There are humming
noises
The compressor is operating.
These noises are quite normal and do not indicate a
fault.
A programme does not
start
No obvious cause.
Connect the tumble dryer to the mains
Turn on the tumble dryer
Close the door
Check whether the mains fuse has tripped
Has there been a power cut? When power is restored
any previously running programme will restart auto-
matically.
Only the
Start/Stop
sensor is flashing.
10 minutes after the end of the programme, the
Start/
Stop
sensor will begin to flash and the display will go
out to save energy. This is not a fault, but a normal
function.
The drum will turn at intervals in the anti-crease
phase.
Touch a sensor to switch on the indicators.
See “Programmable functions”, section “
Control
panel switch-off status”.
The dryer is switched
off at the end of the
programme.
This dryer switches off automatically to save energy.
This is not a fault, but a normal function.
To switch the dryer on, select a programme.
The interior drum light-
ing does not come on
The drum lighting will switch off automatically ...
... when the door is closed.
... after a few minutes when the door is open (to save
energy).
If the dryer is switched on, the drum lighting will
come on when the door is opened.
Содержание TWH620WP
Страница 80: ......
Страница 81: ......
Страница 82: ......
Страница 84: ...M Nr 10 996 850 00 en GB TWH 620 WP ...