Miele TOUCHTRONIC T 9820, Инструкции по эксплуатации и монтажу

Страница: 21 / 56

The laundry is not dry enough.
Possible fault Solution
The load contained too many
dissimilar items (size and fabrics.) – Continue drying using the "Warm air"
program.
– Select a suitable program.
The laundry is still wet. The program runs too long.
The gas supply is insufficient. Check if the gas shut-off valve is closed.
The drum light does not come on.
The light turns off automatically
(energy saving). Close and open the door, the light should
come on.
The bulb may be bad or burned
out. Change the light bulb.
See "Dryer Care".
The program runs too long or stops.
Important: To fix the following problems, open and close the dryer door.
The air supply is insufficient. Open a window or door to increase air flow.
The lint filter is clogged with lint. Clean the lint filter.
The exhaust hose or the
connection is clogged with lint. – Check the exhaust parts (e.g. wall vent
duct, louvered wall vent, bends, etc.)
regularly for air permeability.
– Remove the lint.
The laundry was not spun
sufficiently in the washer. Spin laundry thoroughly before drying.
The dryer is over loaded. Regard the maximum load size per
program.
Metallic zippers prevent a correct
measurement of the laundry’s
residual moisture. – Open the zippers of the laundry before
drying.
If the problem persists, dry items with long
zippers using the "45 min. warm" program,
if necessary use the laundry basket.
Frequently asked questions
21