Programmable functions
70
Conductivity
This programmable function should
only be altered if the water is so soft
that it is likely to cause the electronics
which sense residual moisture in the
laundry to give false readings.
Options
=
Off (factory setting)
= Low
Important
This programmable function should only
be set if the water used for washing the
laundry is extremely soft with a con-
ductivity reading (electrical conductivity)
of less than 150 μS/cm. Contact your
local water authority for the conductivity
level of your mains water supply.
Make sure that you only activate
for the condition described above.
Otherwise, drying results can be un-
satisfactory.
Control field standby status
To save energy, the time display and
sensor controls will go out once the
programme has been running for
10 minutes. In this case, the
Start/Add
laundry
sensor control flashes slowly.
However, there is no switch-off in the
event of a fault.
Options
=
Off
The time display and sensor
controls do not go out.
=
On (factory default setting)
The time display and sensor
controls will go out once the
programme has been running
for 10 minutes.
“Switching on” the display again
– Touch the
Start/Add laundry
sensor
control. This will not affect a running
programme.