Miele PW 6107, Руководство по эксплуатации

Страница: 26 / 80

Fault messages
,
Repairs to electrical or steam appliances
should only be carried out by a Miele authorized
technician in accordance with local and national
safety regulations. Unauthorized repairs could
cause injury or machine damage.
Faults that occur before or after the start of a program
flash in the display.
If the display remains off, the washer has no power.
^
Check the plug, main switch and fuses on-site.
y
Power failure
Program stop.
Press Start.
f
^
Press "START".
This fault message can also indicate that the overload
cut-out of the drive motors has over heated.
^
Allow the motor to cool.
M
Water intake fault
Contact Technical Service
if restart w/o success.
i f
^
Check the water supply and press "START".
a
Door lock fault.
Contact Technical Service
if restart w/o success.
i f
^
Press the door handle so that it closes with a click,
press "START".
§
Heating system fault
Program stop. Press Start.
Program runs with cold water..
i f
^
Press "START" to continue the program without
heating.
If the program has a "Thermostop" the program will
time out.
^
Contact Miele Technical Service.
^
Some programs may be canceled if this messages
shows.
Contact Technical Service.
m
Drive motor fault
Program stop. Press Start.
Motor temperature too high.
i f
^
Allow the motor to cool.
§
Imbalance fault
Contact Technical Service
if restart w/o success.
i
A
Large imbalance, the imbalance switch has
activated.
^
Turn the machine off and on again
^
Press "START".
q
Drain valve fault
Contact Technical Service
if restart w/o success.
i f
^
Check and clean the drain system and press
"START".
A defective drain valve should only be replaced by
an authorized service technician.
Frequently asked questions
26