Miele KM 404, Руководство по установке

Страница: 20 / 40

Fixing the support brackets
^
Position the two support brackets
supplied
a
in the positions shown in
"Fitting the spacer bars and support
brackets" so they are flush with the
top edge of the cut-out and secure
using the 3.5 x 25 mm screws
supplied. 2 screws are needed to
secure each support bracket.
The thickness of the worktop will
determine which drill hole is used.
Granite worktops
On a granite worktop a hole must be
drilled
d
at the position indicated to
secure each support bracket.
^
Using a piece of strong, double-
sided adhesive tape position the
support brackets supplied
a
at the
positions indicated flush with the top
edge of the worktop and secure each
bracket with one screw in hole
d
as
shown.
Building in the gas hob
^
Place the gas hob in the prepared
cut-out.
^
Feed the electricity connection cable
through the cut-out and connect.
^
Make the gas connection.
(see relevant section).
^
Secure the gas hob from below
through the middle elongated hole
b
in each support bracket using the
four screws supplied. Carefully adjust
the hob if necessary.
Installation KM 414 / KM 417
20