![background image](http://html.mh-extra.com/html/miele/kfn-8997-se-ed/kfn-8997-se-ed_operating-and-installation-manual_236576019.webp)
=
5
is the default setting for the
StayFresh zone. If a setting of
=
1
to
=
4
is selected, the temperature can
fall below 0°C. Food could freeze!
^
Press the Super freeze button to save
the setting.
^
Press the freezer section On/Off
button to come out of the setting
mode.
The electronics will then switch over to
normal operation after a couple of
minutes.
Temperature displays
During normal operation the
temperature display shows the
temperature in the middle of the
refrigerator section and the temperature
in the warmest part of the freezer
section.
If the temperature in the appliance is
not within the range that the appliance
is able to display (above 0 °C in the
refrigerator section and below 0 °C in
the freezer section), bars will flash in
the temperature displays.
The
temperature displays flash
, if
– a different temperature is being set,
– the temperature in the appliance has
risen by several degrees, indicating
that the appliance is warming up too
much.
This loss of coldness is no cause for
concern in the following circumstances:
– if the door has been left open for a
while, e.g. for removing or storing a
large amount of food,
– when fresh food is being frozen.
However, if the temperature in the
freezer section remains above -18 °C
for a long time, check that the frozen
food has not started to defrost. If it has
started thawing, check that the food is
safe to use and if it is, use it as quickly
as possible.
Temperature display brightness
The appliance is supplied with the
brightness of the temperature display
set as low as possible. However, if the
door is opened, a setting changed or if
the alarm is sounding, the temperature
display will appear much brighter for
approx. 1 minute.
You can adjust the level of brightness:
^
Press and hold the Super freeze
button for approx. 5 seconds.
The Super freeze indicator light flashes
and a
;
flashes in the temperature
display.
^
Press one of the temperature selector
buttons repeatedly until an
^
appears
in the display.
The correct temperature
19