![background image](http://html.mh-extra.com/html/miele/k-854-i-1/k-854-i-1_operating-and-installation-manual_236471027.webp)
This appliance must be built in,
otherwise it could tip up.
Location
The appliance should be installed in a
dry, well-ventilated room.
The room temperature should not go
above or below the climate range for
which the appliance is designed. The
higher the ambient temperature of the
room, the more energy the appliance
requires to operate.
It should not be installed where it is
exposed to direct sunlight or directly
adjacent to a heat-producing appliance
such as an oven or a radiator.
Climate range
The appliance is designed for a use
within certain climate ranges (ambient
temperatures). It must not be used in
ranges for which it is not designed. The
climate range of this appliance is stated
on the data plate inside the appliance.
Climate range
Ambient room
temperature
SN
N
ST
T
SN - ST
SN - T
+10 °C to +32 °C
+16 °C to +32 °C
+18 °C to +38 °C
+18 °C to +43 °C
+10 °C to +38 °C
+10 °C to +43 °C
Operating in a room which is too cold
will cause the cooling system to switch
off for too long, causing the internal
temperature in the appliance to rise
with the risk of food deteriorating and
going off.
Ventilation
Air at the back of the appliance gets
warm. The appliance housing unit must
be constructed to allow sufficient space
for ventilation. Miele kitchen units are
designed to provide this ventilation.
A ventilation gap of at least 50 mm
depth must be allowed for behind the
appliance for air to circulate.
The air inlet to the appliance is via the
plinth in the housing unit.
The cross section of the air inlet and
outlet must be at least 200 cm
2
to
ensure that air can circulate without
hindrance. Otherwise the appliance has
to work too hard resulting in an increase
in electricity consumption.
The air inlet and outlet must not be
covered or blocked in any way.
They should be dusted on a regular
basis.
Before installation
^
Before installation remove the sealing
strip etc. from the outside of the
appliance and take any accessories
out of the inside of the appliance.
^
Remove any cable clips from the rear
of the appliance.
^
Check that all parts at the rear of the
appliance are unhindered. Remove
any hindrance.
Installation
27
Содержание K 854 i-1
Страница 29: ...Appliance height mm a Niche height mm b K 854 i 1 1393 1397 1413 Building in dimensions 29 ...
Страница 37: ... Place all covers in position Building in 37 ...
Страница 38: ...38 ...
Страница 39: ...39 ...