Factory default setting
If you have altered any settings from
the factory default, you can re-set them
back to the factory default settings as
follows:
^
Open the door.
^
Switch the dishwasher off with the Off
button
V
.
^
Press the programme selector button
in, and
whilst holding it in
switch
the dishwasher on using the On
button
U
.
Keep the programme selector button
pressed in until the lower right hand
programme indicator comes on.
If this does not happen, start the
procedure from the beginning again.
^
Press the programme selector button
briefly 12 times.
The "Inlet/Drain" check light will give
one long flash and two brief flashes at
intervals.
The upper right hand indicator shows
whether a setting other than the factory
default setting has been set.
– If the upper right hand indicator is
flashing:
All settings are factory default
settings.
– If the upper right hand indicator is
not lit up:
At least one setting has been altered
from the factory default setting.
^
If you want to re-set the factory
default settings, press the
programme selector button for at
least one second until the "Inlet/Drain"
check light comes on.
^
Press the programme selector button
briefly.
The setting is now stored in memory.
^
Switch the dishwasher off with the Off
button
V
.
Additional functions
35
Содержание G 1162 SCVi
Страница 61: ...61 ...
Страница 62: ...62 ...
Страница 63: ...63 ...
Страница 64: ...Alteration rights reserved G1162 0410 M Nr 07 502 100 01 ...