Miele cva 610, Техническая информация

Страница: 90 / 107

Technical Information
80
CVA610 Coffee System
5.40
Grinder Unit - Assembly & Basic Setting
Refer to Figure 5-43 on the previous page…
Note
The grinder ring (Item 6), and grinder cone, (Item 5), should only
be exchanged together.
1. Fit the felt ring (Item 11).
2. Fit the carriers (Item 10).
3. Fit the mounting (Item 7).
4. Fit the springs (Item 9).
5. Fit the balls (Item 8).
6. Fit the grinding cone (item 6); ensure the balls are seated in the
grinding cone.
7. Fit the washer (Item 3).
8. Fit the intake worm gear (Item 2), press it down, and turn it until
the coupling engages.
Note
The grinding cone fixing screw (Item 1), has a left-hand thread.
9. Tighten the grinding cone fixing screw, (Item 1), counter
clockwise. Ensure the intake worm gear coupling has engaged
properly.
Note
Before setting the grinder, remove all coffee from the grinder.
10. Fit the bracket (Item 3).
11. The blue marking on the carrier (Item 2), has the same position
as the blue marking on the adjustment ring (item 1); both point
toward the front of the appliance.
12. Turn the adjustment ring clockwise as far as possible.
13. Turn the adjustment ring counterclockwise by 6 settings so that
the adjustment lever can be secured at a mid setting.
14. Fit the adjustment lever such that the grinder is set to a medium
grinding grade.
15. Tighten the adjustment lever fixing screws.
16. Push on the handle.