Initial commissioning
23
Setting the rinse aid dosage
You can adjust the rinse aid dosage for
best results.
The rinse aid dosage can be set from 0
to 6 ml.
3 ml is the factory default setting.
The rinse aid dosage can turn out to be
higher than the set value due to the
automatic adjustment of the program.
If spots appear on dishware:
- Increase the rinse aid dosage.
If clouding or smearing appears on
dishware:
- Decrease the rinse aid dosage.
Open the door.
Turn the dishwasher off with the
button, if it is turned on.
Press the
button in and,
while
holding it in
, turn the dishwasher on
using the
button.
Keep the
button pressed in for at
least 4 seconds until the
indicator
light comes on.
If this does not happen, start the
procedure from the beginning again.
Press the
Program
button 3 times.
The top left program indicator light will
flash rapidly 3 times at intervals.
The set value will appear in the display
after
.
will start flashing in the time display.
Setting 3 is set.
Use the
button to select the
required setting.
The dosage amount increases each
time you press the button. When the
highest value is reached, the setting
starts again from the beginning.
The setting is now saved.
Turn the dishwasher off with the
button.
Содержание 11 848 190
