Midstream Docker 150, Руководство по установке

Страница: 2 / 9

2 3
DOCKER SERIES INSTALLATION GUIDANCE midstreamlighting.com +44 (0) 207 584 8310
INSTALLATION INSTRUCTIONS INSTALLATION INSTRUCTIONS
Contents
1. General notes
Equipment list H&S check
Section PAGE
1 General notes 3
2 Safety instructions 3
3 Contents 4
4 Bracket mounting and aiming 5
5 Type S bracket mounting 7
6 Floodlight connection 9
7 Electrical connection 10
8 Electrical specifications 12
9 Dimensions 13
This user manual contains important information on safe
operation of the Luminaire.
Read and follow all safety notes and all instructions.
Save this manual for future reference.
Make sure that it is available to all persons using this device.
All wiring should be done by a licensed electrician in
accordance with state codes, local codes, and National
Electric Code (NEC) standards or International Electro
technical Commission (IEC) standards.
The Luminaire is suitable for wet locations.
DO
9
Store the Luminaire with care, avoiding placing the lenses
to the ground which may scratch or damage them.
9
To avoid damaging the Luminaire, keep it in the original
packaging when storing.
9
To avoid damaging the Luminaire, keep it in the original
packaging when storing.
DO NOT
8
Apply mains voltage through the control system cable.
This will damage the luminaire that will no longer be
covered by warranty.
8
Unnecessarily remove the Luminaire from the box
8
Leave the LED Luminaire switched on when rested on the
ground with optics facing down.
8
Place the Luminaire with the lens on the pavement, dirt
and metal surfaces.
8
Clean the lenses with any industrial detergent, but with
water-soaked cloth if needed
Two persons required to
complete the installation
Contains parts and
assemblies susceptible to
damage by electrostatic
discharge (ESD)
The Luminaire should
be positioned so that
prolonged staring into the
luminaire at a distance
closer than 4 m (13 ft) is
not expected
Hard hats, safety
shoes, Hi-Vis vest and
safety gloves must
always be worn
Disconnect the electrical
supply power before
commencing the
installation: failure to do
so could result in serious
injury
The luminaire is not to be
placed face down on any
surface other than the
provided foam pad
The light source of this
appliance must only
be replaced by the
manufacturer, its
after-sales service or
qualified personnel
DO NOT USE A
GENERATOR!
2. Safety instructions
Use the device only as described in this user manual. Any other
use or use under other operating conditions is considered to be
improper and may result in personal injury or property damage
as well as voiding the warranty.
No liability will be assumed for damages resulting from improper
installation. This device may be used only by persons with
sufficient physical, sensorial, and intellectual abilities and having
corresponding knowledge and experience.
Note
Prior to start the installation, check the equipment list to be sure of using the correct
tools (the mounting screw(s) and nut(s) are not supplied).
DO NOT USE PERCUSSION DRILLS !
21 mm standard wrench
#6 allen key
#8 allen key
18 mm standard wrench
24 mm standard wrench
30 mm standard wrench
Monkey pliers
Electrician scissors for wires
Slotted manual screwdriver for connector’s screws
(blade dimensions: 3,5(w) x 0,6(t)mm)
Wear safety shoes to protect yourself from material
dropping
Never energize the lamp if wiring operation are not
completed