MidNite Classic 150-SL, Руководство пользователя, Страница: 27 / 43

Classic SL owner’s manual REV E 2056
27 | P a g e 1 0 - 0 0 1 - 3 R E V : E
Troubleshooting / FAQs
How do I do a software
Factory Restore on my
Classic or Classic SL? *Note this only works on the Classics with Displays not a Classic Lite with the
MNLP (LED Panel)
*Warning this will erase ALL settings.
*Turn the PV breaker and Battery breaker off (What you don’t have a breaker?
Get one asap) and make sure the display has gone dark
*Hold the left and right arrow and turn on JUST the battery breaker, Continue
to hold the arrow buttons until you see the Quick Start pop up
*Follow the on screen prompts to set up your controller.
WARNING: You must get the battery charging voltages from the battery
manufacturer and it is VERY important you do this and do not just leave it as
default settings as it is likely this will undercharge and slowly destroy your
batteries
WARNING: The Clock is a 24 hr clock. Setting it off by 12hrs will cause it to
reset to a new day at Noon.
How do I do a
HARDWARE factory
restore? *Warning this will erase ALL settings.
*Turn the PV breaker and Battery breaker off (What you don’t have a breaker?
Get one asap) and make sure the display has gone dark
Do a hardware factory restore. There are 4 sets of jumpers directly above the
blue terminal block. For the purpose of this we will call the left most jumper
JP1 and the right most JP4 (actually labeled "Boot")

Step 1- Turn the PV and Battery power off to the Classic and remove
the front cover

Step 2- Locate the 2 jumpers JP1 and BOOT (JP4). Take the actual
jumpers and keep them in your hand

Step 3- Turn the Battery power on to the classic

Step 4- within 1 minute place jumper JP4 on its two pins and then place
jumper JP1 on its two pins. at this point the 3 leds on the top of the
circuit board should flash back and forth for about 60 seconds.

Step 5- After the flashing stops power down the classic and remove JP1
and JP4 and stow them back on a single pin like they were.

Step 6- Put the front cover on and power up the Classic Lite. If you
have the MNLP set to Custom you will need to go to the local app and
reset the battery voltage and setpoints etc.
What is a “VMM”? *It has become industry slang for our factory restore “Vulcan Mind Meld”
from the 2 fingers needed to push the arrows