MidNite Solar MNKID-B, Руководство пользователя

Страница: 12 / 16

Midnite Kid Basic Solar Charging Kit
12 | P a g e 1 0 - 4 0 4 - 1 R E V -
Estimate the length of wire needed to go from the Big Baby to the KID terminal block. Cut and install two #10
negative wires of appropriate length to the negative bus bar, then two #10 positive wires to the top of the
two breakers (the - - end). Pass all four wires out of the top strain relief. Connect your Earth ground wire to
the Ground busbar and run that out the top of the KID with the other four wires.
Run all five wires through the conduit tubing.
Important:
The circuit breaker torque value is 20 inch-pounds
(2.3NM). You should tighten to this specification during installation
and again one hour after the installation is powered up. Do not
omit the second tightening! A loose wire can cause arcing, melting
of bus bars and fire.
Once the conduit adapter is in place on the BabyBox and the Kid
you can connect the flex conduit to them. Twisting clockwise while
pushing onto the end of the adapter will tighten it.
(HINT) The warmer the conduit the more flexible it is. If you find
that you can’t get it over the top of the adapter heating it up with a
hair dryer or hot air gun will help.