Midland SIDE DUMP GRAVEL TRAILER, Руководство оператора

Страница: 68 / 101

56
8 Stud
5 Spoke 3 Spoke
6 Spoke
M22 x 1.5
(33 mm or 1-1/2 Hex)
M20 x 1.5
(30 mm Hex)
450 - 500
280 - 330
3. Rim/Wheel (Cast Spoke):
a. Inspect and clean all the parts. Replace any
damaged components.
b. Place rims and spacer band on wheel. Be
sure to space valve stem between spokes.
c. Secure clamps evenly in position.
d. Snug up the nuts in the alternating sequence
shown to allow the inside rim to seat itself on
the mounting bevel and avoid wheel wobble.
e. Tighten the nuts evenly in small increments in
the shown alternating sequence until all nuts
are tightened to their specified torque.
Table 7 Recommended Wheel Bolt
Torque (Spoke Wheels)
150 - 175
210 - 260
5/8" - 11
3/4" - 10
Table 6 Recommended Wheel Bolt Torque
10 Stud
Fig. 52 HUB PILOTED
5.2.6 WHEELS (cont'd)
2. Hub Piloted Wheels:
a. Mount inner wheel on the hub.
b. Slide on the hub guide until the wheel is snug
against the hub. Be careful not to damage
the threads on any of the studs.
c. Mount outer dual wheel on the hub and snug
up against the inner wheel.
NOTE
Add a drop or 2 of oil on the end of the
bolt, threads and the nuts and flanges.
d. Install nuts and tighten in alternate sequence
shown.
Stud
Size
Ft-lbs
Torque
(Oiled)
Bolt Size Ft-lbs Torque (Dry)
Fig. 53 RIM/WHEEL TORQUE SEQUENCE
IMPORTANT
Do not over-torque fasteners. Over-
torquing can strip threads, collapse
spacers or lead to other problems
that cause loose fasteners. Use
an accurate torque wrench when
tightening fasteners.