Midian SVR-1-IC1, Руководство пользователя

Страница: 13 / 20

13
HARDWARE INSTALLATION
Be certain to follow standard anti-static procedures when handling any of Midian’s products.
Icom F-3 :
Remove W2 to open the radio’s TX path, W10 to open the radio’s RX path, and W1 to open the radio’s PTT path.
Plug the unit into the options connector located behind the rubber stopper under the battery. These instructions
are for radio serial numbers 50,000 and higher.
Icom F-4 :
Remove W2 to open the radio’s TX path, W12 to open the radio’s RX path, and W1 to open the radio’s PTT path.
Plug the unit into the options connector located behind the rubber stopper under the battery. These instructions
are for radio serial numbers 50,000 and higher.
Icom F-3G, F-4G:
Open jumper C to open the radio’s TX path, jumper F to open the radio’s RX path, and Jumper D to open the
radio’s PTT path. Plug the unit into the options connector located behind the rubber stopper under the battery.
Icom F-14, F-24:
The unit plugs into the options connector under the battery. Before plugging the unit in, open jumper MIC to open
the radio’s TX path, jumper DISC to open the radio’s RX path and jumper PTT to open the radio’s PTT path.
Icom F-30, F-40 :
Open jumper CP C to open the radio’s TX path, jumper CP A to open the radio’s RX path, and jumper CP B to
open the radio’s PTT path. The unit plugs into the options connector located on the main board.
Icom F-30G, F-40G :
Open jumper B to open the radio’s TX path, jumper A to open the radio’s RX path, and jumper G to open the
radio’s PTT path. The unit plugs into the first options connector (labeled as Option One) located on the main
board.
Note: Some F-30G, F-40G radios have an issue that when jumper G is cut, the radio still does not open the PTT
path. If this occurs it will be necessary to program the unit as PTT Common with a low negative logic.
Icom F-33G, F-43G:
The unit plugs into the options connector under the battery. Before plugging the unit in, open jumper C to open
the radio’s TX path, jumper F to open the radio’s RX path, and jumper D to open the radio’s PTT path.
Icom F-70, F-80:
Before installing the unit, open the radio’s TX path by opening CP-1, open the RX path by opening CP-2, and
open the PTT path by opening CP-4. The unit plugs into the options connector located on the main board.
Icom F-120, F-220 :
Before installing the unit, open the radio’s TX path by opening the MIC jumper, open the RX path by opening the
DISC jumper, and open the PTT path by opening the PTT jumper. The unit plugs into the options connector
located on the main board.