Midian Electronics MOT-TVS-2-PRO, Инструкция по эксплуатации

Страница: 11 / 24

11
1B
PRODUCT PROGRAMMING
Install the MPS programming software if you have not done so already. The MOT-TVS-2-PRO series version 2.8
and higher can be programmed via the Motorola RIB box.
Start the MPS software. From the product selection screen on the MPS software, locate and select MOT-TVS-2-
PRO or MOT-VPU-15-PRO and the desired model and click OK. The following table shows the proper MPS
selection based upon the model scrambler ordered.
PRO (MDC Portable)
MOT-TVS-2-PRO or MOT-VPU-15-PRO
PRO (LTR Portable) MOT-TVS-2-PRO MOD-1290 or MOT-VPU-15-PRO-MOD-1290
PRO-E (5-Tone Portable) MOT-TVS-2-PRO-E, MOT-VPU-15-PRO-E, MOT-TVS-2-PRO-E MOD-1323 or
MOT-VPU-15-PRO-E MOD-1323
PRO-XP MOT-TVS-2-PRO-XP or MOT-VPU-15-PRO-XP
Configure the programming software by selecting File->Preferences. Select the appropriate COM port. If using the
RIB box, make certain there is a check mark next to ‘Rib Box Enable’ by clicking on it.
Set the parameters of the MOT-TVS-2-PRO software to fit the application. If any clarifications on a feature are
required, move the mouse cursor over the feature name until the question mark appears and right click, an on-line
help for that feature will be shown. On the radio tab it is necessary to select the proper Radio Model. If the correct
product was selected in the step above then it will be preset in the default file. The following table indicates the
proper Radio Model Selection for the scrambler ordered:
(8) MDC/LTR Portable
MOT-TVS-2-PRO, MOT-VPU-15-PRO, MOT-TVS-2-PRO MOD-
1290 or MOT-VPU-15-PRO-MOD-1290
(4) 5-Tone or MPT Portable MOT-TVS-2-PRO-E, MOT-VPU-15-PRO-E, MOT-TVS-2-PRO-E
MOD-1323 or MOT-VPU-15-PRO-E MOD-1323
(9) MDC/LTR Portable with 4-Line Display MOT-TVS-2-PRO-XP or MOT-VPU-15-PRO-XP
After entering the parameters, save the file by going to File - Save As. Enter the file name in the File Name block
and click Save. Saving the file will allow for quick and easy reprogramming of units. Turn power on to the radio
and then the RIB. Click ProgramUnit! in the MPS software. You will hear 1-3 beeps from the radio if programmed
successfully.