Midian Electronics MOT-TVS-2-PRO, Инструкция по эксплуатации

Страница: 10 / 24

10
Reassembling the Radio:
Additional assembly instructions are also available in Motorola’s Basic Service Manual.
1. Reinstall the RF shield over the Midian board, by first inserting the 2 top tabs and then snapping the 4 arm
tabs back into place with a small flat blade screwdriver. Be certain the board is squarely aligned and not to
damage the flex cables. The RF shield may bulge slightly in the center; this is normal.
2. Place the chassis into the front cover. Be certain the O-ring seal is properly aligned and does not get
damaged. Push the chassis up into the case and then push the bottom down until it snaps.
3. Replace the knobs, antenna and battery.
HARDWARE ALIGNMENT
The MOT-TVS-2-PRO series does not require any hardware adjustments, however, when ordering the scrambler,
the radio it will be used in must be specified. The scrambler will come modified by Midian for the proper model of
radio. If for some reason you decide to modify the board because the radio changes, the table below indicates the
parts to change. For example if changing a PRO module into a PRO-E; R-3, R-12, R-21, R-23, and R-25 would
need to change values and C-5 would need to be removed.
Scrambler Model R-1 R-3 R-12 R-21 R-23 C-5 RC-18 R-25
PRO 750 K 300 K 47 K 100 K 150 K 39 p Not Used 47 K
PRO-E 750 K 470 K 36 K 150 K 62 K Not Used Not Used 100 K
PRO MOD-1290 750 K 910 K 36 K 130 K 47 K 39 p Not Used 47 K
PRO MOD-1323 910 K 910 K 27 K 91 K 62 K Not Used Not Used 62 K