GD Midea Refrigerant Equipment Co. Ltd Service manual for Electrolux split Series
12
sufficiently tighten the flare nut by hand.
2.4.3.2 Finally, tighten the flare nut with torque
wrench until the wrench clicks.
●
Tighten the flare nut with a wrench, in
accordance with the following table.
Outside
Diameter
Tightening
Torque
(Kg.m)
Additional
Tightening
Torque (Kg.m)
1/4” (6.35mm)
1.6
2.0
3/8” (9.53mm)
3.0
3.5
1/2” (12.7mm)
5.0
5.5
5/8” (16.0mm)
7.5
8.5
2.5 CONNECTING THE CABLE BETWEEN
INDOOR UNIT AND OUTDOOR UNIT
Max. current
(A)
Circuit Breaker /
Fuse Rating (A)
Wire Size
(mm
2
)
<=8 10
>=1.0
>8 & <=12.5
16
>=1.5
>12.5 & <=16
20
>=2.5
>16 & <=25
32
>=4.0
>25 & <=32
40
>=6.0
Max. current (A): Detail in SPECIFICATIONS list.
Note:
To be used as a guide only.
2.5.1 Connect the cable to the indoor unit
●
Connect the cable to the indoor unit by
connecting the wires to the terminals on the
control box individually according to the outdoor
unit connection. (Refer to Wiring diagram.)
(Ensure that the color of the wires of the outdoor
unit and the terminal number are the same as
CAUTION
Ensure that all electrical work complies with
relevant Standards and Supply Authority
Service Rules.
An individual branch Circuit Breaker/Fuse must
be used with this Air Conditioner. See the
table following for electrical requirements.
Notes:
●
Power Source and Power Cord
specifications must comply with requirements
following.
●
Circuit Breaker or Fuse specified in this
manual must be installed in the power supply
circuit.
●
For your safety and protection, this unit is
earthed through the power cord plug when
plugged into a matching wall receptacle.
●
Do not connect two power cords together to
supply power to the air conditioner.
●
Do not extend the power cable conductors
by cutting.
●
Power supply should be in the range of
90%~110% of rated voltage.
●
Refer to the attached Electrical Connection
Diagram located on the panel of the outdoor
unit to connect the wire.
