Midea MW120WWBA2RC1, Руководство оператора

Страница: 16 / 72

User Manual
Key Pad Features
Oper
ating
Instruc
tions
This new temperature will be maintained for 7
hours before it returns to the originally selected
temperature. This ends the Sleep mode and the
unit will continue to operate as originally
programmed. The Sleep mode program can
be canceled at any time during operation by
pressing the Sleep button again.
CHECK FILTER FEATURE:
Press Check filter button to initiate this feature.
This feature is a reminder to clean the Air Filter for
more efficient operation. The light will illuminate
after 250 hours of operation. To reset after
Cleaning the filter, press the Check Filter button
and the light will go off.
CONNECT FEATURE:
Press CONNECT button for 3 seconds to turn off
the unit and initiate smart connection mode.
ENERGY SAVER FEATURE (ECO ):
Press Energy Saver button to initiate this function.
This function is available on COOL, DRY, AUTO
(only AUTO-COOLING and AUTO-FAN) modes. The
fan will continue to run for 3 minutes after the
compressor shuts o
ff . The fan then cycles on for 2
minutes at 10 minute intervals until the room
temperature is above the set temperature, at
which time the compressor turns back on and
Cooling resumes.
Before you begin, thoroughly familiarize yourself with the control panel as shown below and all its
functions, then follow the symbol for the functions you desire. The unit can be controlled by the unit
control alone or with the remote.
Electronic Control Operating Instructions
Air Conditioner Features
Energy
Saver
LED
Display
Clean
Filter
Timer
Button
Power
Button
Sleep
Button
Fan
Button
Up ( ) and Down ( )
Buttons
Mode
Button
Connect Indicator Light
(Smart models only)
TO TURN UNIT ON OR OFF:
.
NOTE: The unit will automatically initiate the Energy
Saver function under Cool, Dry, Auto modes.
TO CHANGE TEMPERATURE SETTING:
Press UP/DOWN button to change temperature setting.
NOTE: Press or hold either UP ( ) or DOWN ( ) button
until the desired temperature is seen on the display.
This temperature will be automatically maintained
anywhere between 62°F (17°C) and 86°F (30°C). If
you want to display the actual room temperature,
see To Operate on Fan Only section.
TO ADJUST FAN SPEEDS:
Press to select the Fan Speed in four steps - Auto,
Low, Med or High. Each time the button is pressed,
the fan speed mode is changed. On Dry mode,
the fan operates on Low speed automatically and
cannot be changed.
On Auto mode,the fan operates on Auto fan
speed automatically and cannot be changed.
SLEEP FEATURE:
Press Sleep button to initiate the sleep mode. In
this mode the selected temperature will increase by
2°F/ 1(or 2)°C 30 minutes after the mode is selected.
The temperature will then increase by another 2°F/
1(or 2)°C after an additional 30 minutes.
Power