R
efriger
at
or
Saf
ety
Oper
ating
R
equir
ements
P
arts and
Fe
a
tu
re
s
Ins
tallation
R
efriger
at
or
Use
R
efriger
a
to
r
Car
e
T
roubleshooting
Bef
or
e
Use
FLUSH THE WATER SYSTEM
After installing the replacement water filter it is important to flush air from
the water line so that water will not drip from the water dispenser.
1.
Turn on the main water supply.
2.
Dispense 2.5 gallons of water (flush for approximately 5 minutes) to
remove trapped air and contaminants from the system.
NOTE:
Do not dispense the entire 2.5 gallon amount continuously.
Depress and release the dispenser pad for cycles of 30 seconds ON
and 60 seconds OFF. In some homes, additional flushing may be
required.
3.
Open the refrigerator door to make sure there are no water leaks
coming from the water filter.
DOOR ALIGNMENT (IF NEEDED)
Door alignment or adjustment can be done on side-by-side model
refrigerators.
1.
Locate the adjusting screws found on the underside of the bottom
corner of the refrigerator door.
After loosening the locking nut by turning it clockwise, turn the door
adjusting screw clockwise to raise the door or counter-clockwise to
lower it.
2.
After one or two turns of the wrench, open and close the refrigerator
door, and check the alignment at the top of the doors.
3.
Tighten the locking nut by turning it counter-clockwise.
4.
NOTE:
If necessary, repeat the above steps until the doors are aligned.
Adjusting nut
Fixed shaft
Leveling feet
Locking nut
Wrench
Left
Right
