Midea MP12SVWBA3RCM, Руководство пользователя

Страница: 9 / 32

 Page 9 
Control Panel Features
Oper
ating
Ins
tructions
Swing (Connect)
Button
Up ( ) and Down ( )
Buttons
Mode
Button
Power Button
Sleep
Button
Fan
Button
Timer
Button
LED Display Wireless Indicator
Swing Button
Used to initiate the Auto Swing feature. When
the operation is ON, pressing the SWING button
can stop the louver at the desired angle.
Connect Button
The swing button is also used to initiate the
wireless connection mode.To initiate the
wireless connection mode, power on the air
conditioner then press the SWING button for
3 seconds. The LED DISPLAY will show ‘AP’ to
indicate the unit is in wireless connection mode.
Refer to the app connection instructions to
finish the connection process.
If the connection is successful, the unit will exit
wireless connection mode and illuminate the
wireless LED. If the connection fails, the unit will
exit wireless connection mode automatically after 8
minutes and the wireless LED does not illuminate.
NOTE: The wireless connection process must be
completed within 8 minutes after powering the
air conditioner on.
Timer Button
Used to initiate the AUTO ON start time and
AUTO OFF stop time program. The timer on
or off light will illuminate depending on the
selected setting.
Fan Button
Controls the fan speed. Press to control the fan
speed in four steps - LOW, MID, HIGH and AUTO.
The selected fan speed light (except AUTO) will
illuminate.
NOTE: Applicable to models with the Constant
Fan feature. In COOL or DRY mode, press the
Fan button for 3 seconds to turn on or off the
constant fan function.
When the function is turned on, the
constant fan light will illuminate,
indicating the fan will run constantly.
When the function is turned off, the
constant fan light will go out, indicating
that the fan will stop when the
compressor stops.
Mode Button
Selects the desired operating mode.
Each time you press the button, a mode
is selected in a sequence that goes from
AUTO, COOL, DRY, FAN and HEAT (Heat
models only). The mode light illuminates
and indicates the selected mode.
Up ( ) and Down ( ) Buttons
Used to increase/decrease temperature
settings in 1° increments in a range of
60°F/16°C to 86°F/30°C or the TIMER
setting in a range of 0 ~ 24hrs.
To change between °F or °C,
simultaneously press and hold the Up
and Down buttons for 3 seconds.
Power Button
Powers the unit on and off.
Sleep Button
Used to initiate the SLEEP operation.
LED Display
Shows the set temperature in °F
(Degrees Fahrenheit) or °C (Degrees
Celsius) and the Auto-timer settings.
While on DRY and FAN modes, it
shows the room temperature.
ON OFF