Midea MP12HMB63, Руководство по обслуживанию, Страница: 9 / 36

www.mideaaircon.com 7
UNIT INSTALLATION (CONTINUED)
•
Keep unit levelled when lifting and sliding it
into wall sleeve. Once it is firmly against front
of wall sleeve, secure with 4 screws and
washers (supplied in the Sleeve Assembly)
through the unit overhang holes. (See Fig. 7
and Fig. 8)
•
Reinstall front panel. (See Fig. 9) Place tabs
over top rail (A). Push inward at bottom until
panel snaps into place (B).
•
If unit is installed where condensation
drainage can drip in an undesirable location,
an accessory drain kit should be installed and
connected to drain system.
4.2 Care and Cleaning
FRONT PANEL AND CASE
Turn unit off and disconnect from power supply.
To clean, use water and a mild detergent. Do not
use bleach or abrasive materials. Some
commercial cleaners may damage the plastic
parts.
OUTDOOR COIL
Coil on outdoor side of unit should be checked
regularly. Unit will need to be removed to inspect
dirt build-up that will occur on the inside of the
coil. If clogged with dirt or soot, coil should be
professionally cleaned. Clean inside and outside
of outdoor coils regularly.
NOTE: Never use a high-pressure spray on coil.