Midea MOAB30-09HFN8-QRD0GW, Руководство по обслуживанию, Страница: 34 / 172


Product Features 7

allows the unit to restart automatically. The module
automatically stores the current settings and, in the
case of a sudden power failure, will restore those
setting automatically within 3 minutes after power
returns.
• If there is a power failure while the unit is running, the
compressor starts 3 minutes after the unit restarts. If
the unit was already off before the power failure, the
unit stands by.
3.11 Louver Position Memory Function
When starting the unit again after shutting down, its
louver will restore to the angle originally set by the user,
but the precondition is that the angle must be within
the allowable range, if it exceeds, it will memorize the
maximum angle of the louver. During operation, if the
power fails or the end user shuts down the unit in the
turbo mode, the louver will restore to the default angle.
3.12 ECO function
• Used to enter the energy efficient mode.
Under cooling mode, press ECO button, the remote
controller will adjust the temperature automatically to
24°C, fan speed of Auto to save energy (but only if the set
temperature is less than 24°C). If the set temperature is
more than 24°C and 30°C, press the ECO button, the fan
speed will change to Auto, the set temperature will remain
unchanged.
• When AC receives signals, such as switch off, Turbo
operation , Silence operation , Self clean operation
, Forced cooling operation, mode setting, Sleeping
mode, or adjusting the set temperature to less than
24°C,it will quit the ECO operation.
• Operation time in ECO mode is 8 hours. After 8 hours
the AC quits this mode.
• When there’s any one temperature sensor in
malfunction, the AC will quit ECO mode .
• Indoor fan will run at auto fan when enter into the
ECO mode .The setting temp. and setting fan speed
can be changed through remote controller signal.
3.13 Self clean(Optional)
• The indoor unit will run at low fan for 16 minutes,
then turn off, if you press “Self Clean” when the unit
is in cooling or drying mode.
• Self Clean keeps the indoor unit dry and prevents
mold growth.
3.14 Follow me(Optional)
• If you press “Follow Me” on the remote, the indoor
unit will beep. This indicates the follow me function is
active.
• Once active, the remote control will send a signal
every 3 minutes, with no beeps. The unit automatically
sets the temperature according to the measurements
from the remote control.
• The unit will only change modes if the information
from the remote control makes it necessary, not from
the unit’s temperature setting.
• If the unit does not receive a signal for 7 minutes or
you press “Follow Me,” the function turns off. The
unit regulates temperature based on its own sensor
and settings.
3.15 Silence (Optional)
Press “Silence” on the remote control to enable the
SILENCE function. While this function is active, the indoor
unit will run at faint breeze(1% fan speed), which reduces
noise to the lowest possible level.
3.16 Supper cool
Press the “Super” button on remote controller under
cooling operation to enter the Super cool function. The
set temperature will change to 17°C,the fan speed shift to
high and drive the room temperature down rapidly.
3.17 Electrical energy consumption control
function
Press the “Gear” button on remote controller to enter the
energy efficient mode in a sequence of following:
Turn off the unit or activate ECO, sleep, Super cool, Silence
or self clean function will quit this function.