Midea MLE41N1AWWC, Руководство пользователя и инструкции по установке

Страница: 14 / 64

14
Grounding requirements
Your dryer must be grounded. If a malfunction or breakdown occurs, the grounding reduces the risk of electrical
shock by providing a path of least resistance for the electrical current. This appliance is equipped with a cord having
an equipment-grounding conductor and a grounding plug. The plug must be plugged into an appropriate outlet
that is properly installed and grounded in accordance with all local codes and ordinances.
Warning
The wiring diagram is located on the back board of your dryer.
t Incorrectly connecting your dryer’s grounding conductor can result in
electric shock. Check with a qualified electrician or serviceman if you are
in doubt as to whether your dryer is correctly grounded.
t
Do not modify the plug provided with your dryer. If the plug does not fit
the outlet, have the correct type outlet installed by a qualified electrician.
t
To prevent unnecessary risk of fire, electrical shock, or personal injury, all
wiring and grounding must be done in accordance with local codes, or in
the absence of local codes, with the National Electrical Code, ANSI/NFPA
No. 70 - Latest Revision (for the U.S.) or the Canadian Electrical Code CSA
C22.1-Latest Revisions and local codes and ordinances (for Canada).
t You are responsible for providing adequate electrical services for your
dryer.
All gas installations must be done in accordance with the National Fuel Code
t ANSI/Z2231 - Latest Revision (for the U.S.) or CAN/CGA - B149 Installation
Codes - Latest Revision (for Canada) and local codes and ordinances.
t Gas dryers installed in residential garages must be raised 18" (46 cm)
above the floor.
t Additionally, a 1/8" (0.3 cm) N.P.T. (National Pipe Thread) plugged
tapping, accessible for test gauge connection, must be installed
immediately upstream of your dryer’s gas supply connection.
t
The dryer must be disconnected from the gas supply piping system
during pressure testing at pressures greater than 1/2 psi (3.5 kPa).
t
On dryers not equipped with a gas union in the dryer manifold, the
instructions shall specify that a listed connector in compliance with the
Standard for Connectors for Gas Appliances, ANSI Z21.24 - CSA 6.10 be
used to connect the dryer to the supply piping.
Certain internal parts are intentionally not grounded and may present a risk
of electric shock only during servicing. Service Personnel - Do not contact
the following parts while the appliance is energized: Control Board and
Temperature-Regulating Thermistor (Located on Blower Housing ).
"# !BB! ""# '( "#