Midea MAD50PS1QGRC, Руководство пользователя

Страница: 11 / 40

Operating
Instructions
Operating
Instructions
· Water can be automatically emptied into a floor
drain by attaching the unit with a water hose (not
included).
· Remove the cover located on the back of water
bucket , then remove the rubber plug. Attach a drain
hose and lead it to the floor drain or a suitable
drainage facility.
2. Continuous draining
Note: When the continuous drain feature is not
being used,remove the drain hose from the outlet
, reinstall the rubber
plug and cover .
Note:
· When you remove the bucket, do not touch
any parts inside of the unit. Doing so may
damage the product.
· Be sure to insert the dehumidifier body gently
all the way into the bucket.
· When you remove the bucket, if there is some
water in the unit you must make the unit dry.
e
Page 9
f
Attach the
hose to the
drain hose
outlet.
Remove the rubber plug
Removing the collected water
There are two ways to remove collected water .
1. Use the bucket
1. Lift the dehumidifier by the handle, separate the
it from the bucket and put it aside.
2. Two ways to pour the water out.
· When the unit is off,if the bucket is full, the unit will
beep 8 times (on some models) and the LED DISPLAY
shows “P2”.
· (For some models)When the unit is on,if the bucket is
full, the compressor turns off and the fan turns off after
30 seconds for drying the water of the condenser , then
the unit will beep 8 times and the LED DISPLAY shows
“P2”.
· Lift the dehumidifier body handle, separate the
dehumidifier body from the tank. Put the dehumidifier
body aside.
· Throw away the water from the water outlet and
replace the bucket.
Note:
· Lift the water bucket and throw away the water.
· Remove the rubber plug at the bottom of the bucket,
drain off the water.
· The machine will re-start when the bucket is restored in
its correct position.
Method A: Lift the water bucket and throw away the water.
Method B: Remove the rubber plug at the bottom of the
bucket to drain off the water.
· Make sure the hose is secure so there are no leaks.
· Direct the hose toward the drain area,making sure
that there are no kinks that will stop the warter
flowing.
· Place the end of the hose into the drain area and
make sure the end of the hose is level or downwards
to let the water flow smoothly. Do never let it up.
· Make sure the hose is lower than the drain hose
outlet.
· Select the desired humidity setting and fan speed
on the unit for continuous draining to start.
Remove the cover