Page 13
ELECTRICAL HEATING FUNCTION
TEMPERATURE DISPLAY FUNCTION
LIGHT SENSITIVE FUNCTION
ECO FUNCTION
Press button SWING and EYE
for one second to turn
the Electrical heating function on or off. A symbol will display on the indoor
unit display after the electrical heating function is activated.
simultaneously
NOTE:
The electrical heating function is activated automatically
when the air condtioner is under heating operation.
To start or stop the electrical heating function by remote control:
NOTE:
In Electrical heating mode, the unit will automatically turn on or off the electrical
heating device based on the operation mode, room temperature and set temperature.
Each press of EYE button for one second will scroll through temperature displays as follows:
NOTE:
The temperature can also be checked when the unit is pluged,
and is not turned on. The temperature display will disappear in 15 seconds.
Set
temperature
Room
temperature
Outdoor
temperature
No display
The brightness of display screen of air conditioner will change
according to the lights of room.
If the lights of room fades, the brightness of the display screen gets weaker.
When the light becomes bright, the brightness of the display screen returns.
If the room light turns off, after a few seconds, the display screen becomes dark.
And the voice of air conditioner buzzer reduces , fan speed shifts to low.when
the room light turns on again, the display screen gets brighter.
The ECO function can only be activated via WIFI control under cooling operation.
The indoor display screen displays ECO . It will hold on for 8 hours, then the
unit will revert back to the previous cooling operation.
NOTE:
The ECO operation may result in insufficient cooling capacity, if the outside
temperature is too high, please do not select this energy saving mode to avoid feeling
uncomfortable.
How to Use Advanced Functions
4
The following are instructions for using your air conditioner s advanced functions.
,
How to Use
Advanced
Functions
EYE
EYE
SWING
NOTE ON LOUVER ANGLES
When using COOL or DRY mode, do not set
louver at too vertical an angle for long periods
of time. This can cause water to condense on
the louver blade, which will drop on your floor
or furnishings. (See
Fig. 6
)
When using COOL or HEAT mode, setting the
louver at too vertical an angle can reduce the
performance of the unit due to restricted air
Do not move louver by hand. This will cause
Do not put anything into the air outlet or hang
anything on it.
the
louver to become out of sync. If this occurs, turn
off the unit and unplug it for a few seconds,
then restart the unit. This will reset the louver.
CAUTION
Do not put your fingers in or near the blower
and suction side of the unit. The high-speed
fan inside the unit may cause injury.
Fig. 7
Deflector rod
How to Use
Basic
Functions
LOCK FUNCTION
Use the LOCK function when you want to prevent settings from being changed accidentally.
Under lock mode, all current settings are locked, and the remote controller will not
accept any operation except that of the LOCK.
Press button and
simultaneously for one second
to activate LOCK function.
Press button and
simultaneously for one second
to cancel LOCK function.
A lock symbol will appear on
the indoor unit display when the lock
function is activated.
A lock symbol will disappear from
the indoor unit display when the lock
function is cancelled.
Page 12
