PART FIGURE
Note: All the pictures in this manual are for explanation purpose only. Any discrepancy between
the real object and the illustration in the drawing shall be subject to the real subject.
2
[01]x1
[06]x1
[02]x1
[03]x1
[04]x1
[07]x1
[05]x1
[08]x1
Circlip
Front Grill
Grill
Clip
Rear Grill Motor
shaft
Internal Pole
Extension Pole
Chassis
7-shape Bolt
Height
adjustment ring
Clutch knob
Motor
housing
Spinner
Blade
Plastic Nut
Thumb
screw
1. Unscrew the 7-shape Bolt
from the Extension Pole. (Fig.1)
2. Insert the extension pole into the chassis and tighten the 7-shape Bolt (Fig.2)
3. From the extension pole loosen the height adjustment ring and adjust the internal
pole to the desired height. (Note: If you can’t find the internal pole, it must inside
the extension pole. You can pull it out from the extension pole.) (Fig.3)
4. To attach the head unit to the internal pole, loosen the thumb screw on the bottom
of the head unit. Place the head unit on the internal pole and tighten the thumb
screw in alignment with the groove on the internal pole. (Fig.4)
CAUTION:
Height adjustment ring must be fully fastened before the assembly of the
motor section to the internal pole.
ASSEMBLY OF CHASSIS & COLUMN UNIT