Removing the Product Piston:
1.
Move the stroke adjust to its most retracted position (as shown).
2.
Depending on the type of piston, it may need to be removed in one of
the following ways:
a.
Unscrew pistons from the air cylinder foot.
b.
Slide the piston head off of the piston rod through the cutout located
on the base of the piston head (shown here).
Removing the Product Cylinder:
1.
Follow the procedure for removing the product piston prior to removing
the product cylinder.
2.
Depending on the type of cylinder, it may need to be removed in one of
the following ways:
a.
Grip the product cylinder and turn counter clockwise to remove.
b.
Use a spanner wrench to loosen the product cylinders from the
product head.
Cleaning the Product Head:
1.
Remove the product valve and cylinder prior to cleaning the product
head.
2.
Use a soft round brush to gently scrub out the ports using a mixture of
approximately 2 gallons of LUKEWARM water with about a teaspoon of
Dawn® or equivalent grease dissolving liquid dish washing detergent.
3.
Rinse with clean water until no residue remains.
Removing the Product Spout:
Depending on the product being dispensed, the product spout can come in
many different styles. All should be detached and cleaned in approximately
the same way (as described below). If further instructions are needed for
your particular spout, please contact the Hinds-Bock corporation for further
diagrams and details.
1.
Begin by detaching the clamps shown.
2.
Be sure to keep the air hoses and cylinder out of the water when
cleaning the spout. Water in the air hoses can cause damage to the
machine.
Pg. 12
