9
ENGLISH
SECTION 2 - INSTALLATION
V. CONVEYOR INSTALLATION
NOTE
Split belt conveyors can only be installed from the end of the
oven with the drive motor.
Single-belt conveyor assemblies may be inserted into either
end of the oven. If it is to be installed from the end of the oven
without the drive motor, the drive sprocket assembly must be
removed.
To remove the drive sprocket (if necessary), loosen the set
screw on the conveyor collar as shown in Figure 2-7. Then, pull
the sprocket assembly straight out.
1. Lift the conveyor and position it in the oven as shown in
Figure 2-8.
Figure 2-8 - Inserting the Conveyor
2. Continue moving the conveyor into the oven until the frame
protrudes equally from each end of the oven (about 457mm).
3. Check that the retainers located on the underside of the
conveyor frame rest firmly against the lower end plug, as
shown in Figure 2-9.
NOTE:
Each oven has retainer clips on the bottom of the conveyor
frame, as shown in Figure 2-9. The clips are only located
on the left (drive) side of the frame.
4. When the conveyor is positioned properly, check for free-
dom of movement of the conveyor belt by pulling it for about
60 to 90 cm with your fingers. The conveyor must move
freely.
5. If the drive sprocket was removed when installing the
conveyor, replace it at this time.
6. Install the drive chain between the conveyor drive sprocket
and the motor sprocket. To install the chain, it will be
necessary to lift the drive end of the conveyor slightly. The
drive motor and sprocket are shown in Figure 2-7.
7. Install the conveyor drive motor cover and tighten its hanger
screw (on the rear wall of the oven).
8. Check the tension of the conveyor belt as shown in Figure
2-10. The belt should lift between 75-100mm. DO NOT
OVERTIGHTEN THE CONVEYOR BELT.
NOTE:
If necessary, the belt tension can be adjusted by turning the
conveyor adjustment screws, located at the idler (right) end
of the conveyor. See Figure 2-10.
Figure 2-9 - Conveyor retainers
Figure 2-10 - Checking the conveyor tension
75-100mm
vertical
deflection
Retainer clip
Figure 2-7 - Removing the Conveyor Drive Sprocket
Loosen conveyor collar
set screw, then pull shaft
straight out
Conveyor
tension
adjustment
screws (idler
end only)
