THREADING THE CAT-6 CABLE AND INSTALLING AVIP PLATES (CONTINUED)
Page 6
SCALE 0.500
C
2. Slide the cable stopper down and through the knockout openings so it sits on the span of Cat 6 cable
outside of your cart. (
FIGURE F
)
3.
Use a power driver, #2 Philips bit, (6x) 4-40 x ½” pan head screws (F), and (6x) 4-40 washer nuts (G)
to attach the AVIP pieces (H) to your cart while making sure to thread the Cat 6 cable and stopper
through the larger hole on the upper right (shaded) as shown. (
FIGURE G
)
5. Pull cable to desired slack and slide the stopper against the outside of the AVIP pieces (H) to secure
the length in place.
4. Use (2x) large (J) and (2x) small (K) rubber grommets to line each hole of your assembled
AVIP pieces as shown. Grommets are cut along circumference. Slip grommets around cables and line
press them into place.
6. Reinstall Lever Lock brackets, 10” Lever Lock plates, 2” channels, devices, cables, and
cable management as necessary. For more information, reverse steps 2, 3, and 4 in “Preparing Your
Cart for Cat-6 Retractor Installation” on page 4.
FIGURE F
X
FIGURE G
NOTE
: Thread the Cat 6 cable and stopper through
the larger hole on the upper right (shaded) while
attaching the AVIP pieces (H) to your cart.
F
G
Shaded locking nuts
(G) indicates location
inside of cart.
Cable
Stopper
