Page 7
MAKING TERMINAL BLOCK CONNECTIONS
!
!
CAUTION:
Use a multimeter to confirm wire polarity before making
connnections or damage to equipment may occur.
ATTENTION:
Utiliser un multimètre pour confirmer la polarité des
fils avant d'effectuer la connexion ou des dommages à l'équipement
peut se produire.
1. Strip 1/4” of insulation from wire ends.
(FIGURE A)
2. Determine correct polarity of po and negative -
wire ends.
3. Select appropriate color-coded terminal block:
A. Orange = 5V DC
B. Yellow = 12V DC
C. Blue = 18V DC
D. Red = 24V DC
4. Insert bare wire ends into terminal block.
5. Tighten connections securely with screwdriver.
6. Insert terminal block into appropriate power bank.
1/4”
+
+
-
-
FIGURE A
RACK EAR INSTALLATION
1. Install rack ears as shown using supplied rack ear screws.
(FIGURE B)
2. Rack ears may be installed in a variety of orientations. For more information, see Rack Ear Mounting
Orientation on page 8.
FIGURE B
F
H
E
NOTE:
The longer rack ear (E) is
installed on the side containing
the IEC socket.
