RACK ASSEMBLY (Continued)
Page 9
FIGURE D
8) Install top trim panel using (2) 10-32 x 1/4” screws.
(FIGURE D)
NOTE:
Top trim panel contains only two screw holes.
9) If equipped, align the edge of the lacer bars with the
outside edge of the rackrail and ensure that the flat
side of the lacer bar is on top. Install the lacer bars
as shown using 10-32 Phillips head screws.
(FIGURE E)
NOTE:
The lacer bars should not be placed in the
bottom 8 rackspaces. The lacer bars on
the rack should be 2 rackspace above or below
the corresponding lacer bars on the rough-in pan.
TIP:
When installing the lacer bars on the rough-in
pan, place the rack with the roller base on the
rough-in pan and mount the equipment in the rack
and position the lacer bars as needed. This will
simplify cable management once the rough-in pan
is mounted into the millwork.
(FIGURE F)
Top Trim Panel
Screws (2)
10-32 x 1/4”
Lacer Bars
Lacer Bar
Rackrail
FIGURE E
FIGURE F
Rough-In Pan
