Midas Pro 6 DL351, Руководство оператора

Страница: 49 / 70

33
DL351 Modular I/O
Operator Manual
Appendix D: Replacing An I/O Module
This appendix provides instructions on module replacement.
Replacing a module
The design of the DL351 Modular I/O makes module replacement very easy and
straightforward. The unit has rack guides in each of the eight module positions so that
the modules can slide easily in and out. Each module is held in place by two screws, at
the left- and right-hand sides. A short metal post (or stud) adjacent to each screw
facilitates removal.
>> To remove a module
1
Switch off the unit and isolate it electrically (see “To switch the unit off” on
page 10).
2
Disconnect all connectors from the rear panel, such as mains, XLRs, USBs etc.
3
Remove the two securing screws at either end of the module you wish to remove
(see Figure 1).
4
Pull out the module using the two circular machined posts (adjacent to the
securing screws).
Figure 1: Location of components involved in module removal
Module securing
screws
Circular machined
post
Circular machined
post