NOTE: If necessary, the wrench is provided for final
tightening of all tension knobs.
6. To fasten your gate firmly in the opening or doorway, start
by turning the BOTTOM Adjustment Wheels first. Continue
to turn the bottom Adjustment Wheels counter clockwise
until the Adjustment Wheels are firmly against the frame.
IMPORTANT: There should be equal space on each side
of the gate. To easily determine this, look at the length of
threaded rod showing. If more threaded rod is showing on
one side you can adjust using the Adjustment Wheels.
Simply turn the side that has too much threaded rod
showing clockwise, and then turn the other side counter
clockwise until all sides are equal.
7. Repeat Step 6 with the TOP Adjustment Wheels. Again,
there should be equal space on each side of the gate. As
you tighten the top you will notice that the gap between the
door latch and the frame will begin to narrow. As the gap
continues to narrow, continue turning the upper
Adjustment Wheels until the door latch and the frame are
engaged. NOTE: If you have not done so already, you can
cut the zip tie that held the door and frame together.
Leave a 1/16” gap between the frame and the door latch
as shown. IMPORTANT: The frame must not touch the door
latch. If it does touch you have turned the Adjustment
Wheels too much. To correct this simply turn the upper
Adjustment Wheels clockwise a few turns until you have
a 1/16” gap. Your gate is now ready to use.
To Verify Installation
Push the gate frame to ensure that it is secure in the
opening and then push the door to ensure that the upper
and lower latches lock securely in the housing of the
frame.
NOTE: If gate is too difficult to unlatch, the Threaded
Spindle Bolts may be too tight.
5
1/16”
