Microtronics myDatalogEASYplus, Руководство пользователя

Страница: 84 / 139

"Digital"
or "digital
LP" mode Event
trigger MS Start measurement cycle immediately
XM Initiate transmission
Edges Selection of the edge at which the trigger should be initiated
rising
Rising edge initiates the trigger.
falling Falling edge initiates the trigger.
both Both edges initiate the trigger.
Level
trigger QU Fastrecording (record interval = record interval / factor)
SL Slow recording (record interval = record interval * factor)
ON Activate online mode
QX The reduced transmission cycle should be used.
Edges not relevant for the level triggers
All other modes QU Fastrecording (record interval = record interval / factor)
SL Slow recording (record interval = record interval * factor)
RO Switch on recording
RF Switch off recording
XM Initiate transmission
ON Activate online mode
QX The reduced transmission cycle should be used.
Level Levels for initiating the trigger. The hysteresis from the "Alarm"
tab is used to determine the level to reset the trigger.
Greater or
equal
The measurement value must be greater or
equal to the level to initiate the trigger.
Less or equal The measurement value must be less or equal
to the level to initiate the trigger.
9.2.1.4 Calculated channels
Note: The values of the calculated channels are directly calculated for every data output (display on the myDatanet
server or download from the myDatanet server). They are not saved in the server database.
9.2.1.4.1 Basis
Title 1-5
Freely selectable channel title for the calculated channels [0-16 characters]
84 Rev. 06